Supersprint Step Design Manifold - BMW 3 Series E46 M3 F82

Supersprint Step Design Manifold - BMW 3 Series E46 M3 F82A good header design is key to unlocking performance gains from naturally aspirated motors. At Supersprint every header is designed, developed and manufactured within their factory in Mantova, Italy. With performance gains the main objective, Supersprint study and design primary and secondary piping configurations with varying diameters and lengths. These are then tested on their in house MAHA Dynamometer enabling them to recognise the optimum setup.

Marked improvement in safety and performance without additional spring changes (standard springs can be used)

A standard car will accelerate well up to 5500rpm but beyond that the power begins to fall

Software is also available to eliminate any engine warning lights when using decat or high flow catalytic converters

This provides a solid/tight fit without the need for welding

Upto 2 second advantage to 100mph over a standard car

Conventional methods of advancing the ignition timing under full load have little effect

Alpha-N S62 V8 Management available as option

please contact us to discuss further

Mountable for:

Evolve are pleased to offer our catless turbo downpipes for the S63B44TU engine found in the F10 M5 & F06/F12/F13 M6

Made from titanium—with some parts cast in Akrapovič’s own foundry—it has bigger pipes than the stock exhaust

Gains are 20 BHP and 20 lb/ft torque