Cutter arbors with parallel key and tenon drive - Dimensions and designation of tool holders with 7/24 taper without automatic tool changer included-in-kit Comments should be sent in

Comments should be sent in writing to the Secretary of BSI Subcommittee CH/210/3

the thermal efficiency is obtained by the direct method of test and is established to within a tolerance of ± 2 % points

The report gives supplementary guidance on the use of all parts of ISO 5167 and information on the use of essential secondary instrumentation

test equipment and set-up as well as the test procedures and content of the test reports

The aims of the ERTMS/ETCS/GSM-R Train Control and Train Radio Systems are standardised systems facilitating interoperable movement of trains and permitting economies of scale in procurement and operations

Cutter arbors with parallel key and tenon drive - Dimensions and designation of tool holders with 7/24 taper without automatic tool changer included-in-kit Comments should be sent in1 Scope This part of ISO 10649 specifies the dimensions of cutter arbors with parallel key and tenon drive with 7 24 tapers without automatic tool changers.