Cutter arbors with parallel key and tenon drive - Dimensions and designation of tool holders with 7/24 taper without automatic tool changer Ingestion-build-180956 The design of the cables

The design of the cables and connectors used will preferably conform to the applicable parts of IEC 61196 and IEC 61169 respectively

BS EN 61212-3-2 has information about property requirements for round moulded tubes as well

BS EN 62129-2 specifies the preparation for performing calibration process

Such purposes can be

NOTE 1 The results obtained by this method give an objective measure of the noise emitted under the specified test conditions

Cutter arbors with parallel key and tenon drive - Dimensions and designation of tool holders with 7/24 taper without automatic tool changer Ingestion-build-180956 The design of the cables1 Scope This part of ISO 10649 specifies the dimensions of cutter arbors with parallel key and tenon drive with 7 24 tapers without automatic tool changers.